HRT-711-UTA CR, Modbus TCP to HART Gateway - acts as a HART protocol Master that allows Modbus/TCP master devices to access data from HART slave devices.
HRT-711-UTA CR
Modbus TCP to HART Gateway - acts as a HART protocol Master that allows Modbus/TCP master devices to access data from HART slave devices.
Free Shipping
Features
- Support HART Short/Long frame
- Support HART Burst mode
- Allow two HART Masters
- Working in point-to-point or multi-drop HART mode
- Connecting up to 15 HART modules
- Support Modbus TCP/UDP server
- Support Modbus Slave mode
- Support firmware update via Com Port
- Support on-line replacement of HART devices
- Support acquire Long Frame Address automatically
- Built-in Watchdog
- Mountable on DIN Rail
Introduction
The HRT-711-UTA Gateway is specially designed for the master device of HART protocol. It allows the Modbus master to access the HART devices. These HART devices may be a transmitter, an actuator and so forth. In addition, we also provide the utility software for users to configure the HRT-711-UTA. By using this module, users can integrate their HART devices into Modbus network easily.
Specifications
COM Ports
Ports: RS-232(3 wires)
Ethernet:
Ports: 10/100Base-TX Ethernet Controller (Auto-negotiating, Auto_MDIX)
HART
Ports: 1
Device: 2-wired or 4-wired HART devices
Topology: Point to Point or Multi-Drop
Data: Only Digital Data
Frame Type: Short and Long Frame
Burst Mode: Supported
Max. HART Device: 15
Loop Resistor: 250 Ω resistor by Jumper
Isolation: UL1577 Spec.
Protocol: 2-pin screwed terminal block
Power
Reverse Polarity Protection: Power reverse polarity protection, Over-voltage brown-out protection
Input Range: Unregulated +10 ~ +30 VDC
Consumption: 1 W
Mechanical
Dimensions (mm): 72 x 35 x 121 (W x L x H) Detail
Installation: DIN-Rail or Wall Mounting
Environment
Operating Temperature: -40 ~ +75 °C
Storage Temperature: -40 ~ +80 °C
Humidity: 5% ~ 95% RH, Non-condensing