I-7570 CR
RS-232/422/485 Serial To HART Converter. Supports operating temperatures between -25 to 75°C
- Support HART Short / Long frame
- Support HART Burst mode
- Support point-to-point or multi-drop HART mode
- Support connecting up to 15 HART slave devices
- Allow two HART masters
- Provide utility tool for module configuration and HART communication
- Provide PWR / TxD / RxD indication LED
- Isolated COM 1: RS-232 / RS-422 / RS-485
- 4KV ESD Protection
- Built-in Watchdog
- Selectable 250Ω load resistor
The I-7570 is a Serial to HART converter designed as the master device of HART protocol. It allows users to access the HART slave by using RS-232 / RS-422 / RS-485. These HART slave devices may be a transmitter, actuator, current output device and so forth. In addition, by using the I-7570 utility tool, users can configure module and test HART communication easily and quickly.
UART Interface
COM 1: RS-232(Tx / Rx / GND) / RS-422 / RS-485
COM 1 Connector: 9-pin screwed terminal block
Baud Rate (bps): 1200
Data Format: O(odd parity), 8(data bit), 1(stop bit)
HART Interface
HART Interface: 2-pin screwed terminal block
HART Channel: 1
LED
Round LED: PWR / TxD / RxD
Power
Power supply: Unregulated +10 ~ +30 VDC
Protection: Power reverse polarity protection, Over-voltage brown-out protection
Power Consumption: 1W
Mechanism
Installation: DIN-Rail or Wall Mounting
Dimensions: 121 mm x 72 mm x 35 mm (H x W x D)
Environment
Operating Temp: -25 ℃ ~ +75 ℃ (-13 to 167 ℉)
Storage Temp: -30 ℃ ~ +85 ℃ (-22 to 185 ℉)
Humidity: 5% ~ 95%, non-condensing